Pa1x noise and problem

dykorg · Post by **dykorg** » Fri Jan 06, 2012 9:02 pm

Hi
I've had a problem with my PA1X longtime and sent it to Korg service to check my pa1x without a solution.
I installed the latest OS to but still same.
Is there anyone here who could be the angel to solve my problem?

When I start my Pa1X everything works as it should be after a while you hear a noise that comes and goes, then the sound goes when I have it on the Style Play mode and can not hear the sound.
Each time the noise stops the sound I have to go into midi then pressing the Local Control deselect and select again the sound comes back and works then. If you do this several times restarting my pa1x automatically.
I'm just going crazy, is there someone who recognizes the problem?

Thanks

bortchy · Post by **bortchy** » Fri Feb 24, 2012 9:18 pm

you try to set volumen on the minimum on voice pocesor preset and voice procesor set up it is posible that make this throuble ,but it can be aother problem to try for now do it maby is microphone gain to high

jazzmammal · Post by **jazzmammal** » Fri Feb 24, 2012 11:37 pm

I had a similar thing and it was the mic input knob on the back. Turn it off and see if that helps although if you've already had it to Korg service you would think they would know to try that.

Bob

dykorg · Post by **dykorg** » Sun Feb 26, 2012 11:07 pm

Thank you for your taking time.
please if you can explaing how i can do that?

dykorg · Post by **dykorg** » Mon Feb 27, 2012 1:18 am

stil same i did that voice gain to of.
do you have a service manual i want open it and check.

Thanks

FSalomon · Post by **FSalomon** » Fri Jul 06, 2012 2:08 am

I have almost the same problem. Except that, I have noise and sound of the instruments are so low that it's not even registering in my daw. Serviceman told me I have to change the PCB Main Board. $1000.

Or 650 to buy and I can put it myself.

Hope this hlelp.

But my question now is the following:

I have midi files in my daw and I need the sounds

1) Can i get the sounds from inside the korg (samples) using usb connection?
2) Can I get a software that will act like the PA1xpro hardware so i can get the sounds.

Basically, how do I get the sounds for my midi?

Thanks.

dykorg · Post by **dykorg** » Wed Jan 23, 2013 11:39 pm

My problem is over now : )
I send my PA1X to a music shop and they have some one who works with digital piano and kyboards.
my problem was electric problem my PA1X did not get enought and he changed that

I have another question??
I think i want to buy PA600,can i load my PA1X sets into pa600 with all my samplings and styls?

Thanks

Reuben · Post by **Reuben** » Fri Jan 25, 2013 5:17 am

If your DAW/Computer can send midi data (you should be able to change output to your computer port within the program) it will work but Pa1x must use the older style (7 pin?) connector and most computers don't have this any more. I think you can get an adaptor to a USB port on your computer.
Would be easier to transfer files to your Pa1x if you have a hard disk and play them that way.