Korg Forums

Downloaded without any problems here.

I have always removed the non English PDFs (manuals) and never had a problem. I cannot see why you would need them or why removing them should cause a problem.

I have my K88 on a Yamaha LG800 - very stable and good looking, but not cheap

https://www.thomann.de/gb/yamaha_lg800.htm

Snorkl wrote:Korg EMX - 1
PLSSSS!!!!
THX

Plus 1 from me, thanks.

After successfully updating both software and firmware today, I notice that some of the organ programs (all the 'eruptions' for instance) have a background noise unless the volume is lowered to around 9 O'Clock. Is this normal and part of the horn spinning emulation? Forgive my ignorance if not ...

Anyone?

After successfully updating both software and firmware today, I notice that some of the organ programs (all the 'eruptions' for instance) have a background noise unless the volume is lowered to around 9 O'Clock.

Is this normal and part of the horn spinning emulation? Forgive my ignorance if not!

Kronik wrote:I did a self install, and made sure the Agility's firmware was up to date before putting it in......

For the less IT savvy of us, can you explain/detail how you did this?

Thanks

I will need to make up those shorter test leads and clips but, in the mean time, I used the same configuration on two other (previously unused) connectors and the readings were consistant. Take my first reading of 0.9-1.0 Ohms for the Tip to Tip, via the patchbay. I measured the leads and got the ...

Makes a lot of sense but being a mech engineer rather than an elec engineer could you give me an idea of what would be classed as low resistance (un-damaged) and what would be classed as high resistance (cooked)? You are expanding my knowledge with every post - thanks again. EDIT: Just tested the ...

OK, thanks for the clear explanation. I'll make sure I use the patchbay for line level ONLY in the future. I have only tried the headphones on one bank (top and bottom) so the maximum damage is 42 way, rather than 48 way. However, I assume that as my post test with the multi-meter gave continuity ...

I have three keyboards and two rack mounted sound modules. The sound modules are a Roland JV-2080 and a Yamaha Motif-Rack XS. I also have two patchbays - a P&R PB48 and a DACS MIDI patchbay. I am successfully using the DACS MIDI patch bay to easily patch any of the three keyboards to either of the ...

Mine is 'RH3 made in Japan', and has NO problem Serial number mid 600s

My K88 is in the mid 600s and says "RH3 Keybed from Japan". Although I've tried to find any sort of problem with it I just can't - seems to be 100% fine.

Awesome