Internal routing

Discussion relating to the Korg Kronos Workstation.

Moderators: Sharp, X-Trade, Pepperpotty, karmathanever

Post Reply
Lightbringer
Senior Member
Posts: 356
Joined: Sun Jan 07, 2018 11:16 pm
Location: USA

Internal routing

Post by Lightbringer »

I was trying to somehow route the output of AL-1 into MOD-7. Ultimately I wanted to set one of the VPM oscillators to Waveshaper mode, and shape AL-1’s output with it.

Doesn’t really seem possible in program mode, so I was trying to use a combi. AL-1 on channel 1, sending its output a few different targets such as IFX1, the record and fx busses. Then MOD-7 on channel 2. In the program itself I used the matrix to route audio in to VPM OSC 1, and OSC 1 to one of the outputs. Set the Audio in for the program to receive from the various sources I set for CH1 in the Combi (IFX1, record bus 1, etc).

Can’t seem to get this to work. MOD-7 never has any signal out.

Anyone done this or have suggestions?
HardSync
Platinum Member
Posts: 849
Joined: Fri Jan 07, 2011 6:18 pm

Post by HardSync »

Try having a look at these two topics for your solution:

http://www.korgforums.com/forum/phpbb2/ ... hp?t=72604

http://www.korgforums.com/forum/phpBB2/ ... hp?t=71882

In that first topic linked, Dan said to do it like this:
danatkorg wrote:You can do this easily in a Combi. For example:
* AL-1 on Timbre 1, routed to any non-sounding bus (e.g. Rec 1/2)
* MOD-7 on Timbre 2, set EXi Input (Combi P:2-6) to match the bus of Timbre 1
- Dan
I'm going to assume that you don't need to make any program level changes to make this routing; it all happens in the combi itself on the EXi audio page P2-6.
Lightbringer
Senior Member
Posts: 356
Joined: Sun Jan 07, 2018 11:16 pm
Location: USA

Post by Lightbringer »

Thank you! Good reads and very helpful. I tried a lot of different things. But not those things. :)

I'll try that and report back.
Post Reply

Return to “Korg Kronos”