Korg Forums Forum Index Korg Forums
A forum for Korg product users and musicians around the world.
Moderated Independently.
Owned by Irish Acts Recording Studio & hosted by KORG USA
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Internal routing

 
Post new topic   Reply to topic    Korg Forums Forum Index -> Korg Kronos
View previous topic :: View next topic  
Author Message
Lightbringer
Full Member


Joined: 07 Jan 2018
Posts: 211
Location: USA

PostPosted: Sat Nov 16, 2019 1:56 pm    Post subject: Internal routing Reply with quote

I was trying to somehow route the output of AL-1 into MOD-7. Ultimately I wanted to set one of the VPM oscillators to Waveshaper mode, and shape AL-1’s output with it.

Doesn’t really seem possible in program mode, so I was trying to use a combi. AL-1 on channel 1, sending its output a few different targets such as IFX1, the record and fx busses. Then MOD-7 on channel 2. In the program itself I used the matrix to route audio in to VPM OSC 1, and OSC 1 to one of the outputs. Set the Audio in for the program to receive from the various sources I set for CH1 in the Combi (IFX1, record bus 1, etc).

Can’t seem to get this to work. MOD-7 never has any signal out.

Anyone done this or have suggestions?
Back to top
View user's profile Send private message
HardSync
Platinum Member


Joined: 07 Jan 2011
Posts: 708

PostPosted: Mon Nov 18, 2019 8:27 pm    Post subject: Reply with quote

Try having a look at these two topics for your solution:

http://www.korgforums.com/forum/phpbb2/viewtopic.php?t=72604

http://www.korgforums.com/forum/phpBB2/viewtopic.php?t=71882

In that first topic linked, Dan said to do it like this:

danatkorg wrote:
You can do this easily in a Combi. For example:
* AL-1 on Timbre 1, routed to any non-sounding bus (e.g. Rec 1/2)
* MOD-7 on Timbre 2, set EXi Input (Combi P:2-6) to match the bus of Timbre 1
- Dan


I'm going to assume that you don't need to make any program level changes to make this routing; it all happens in the combi itself on the EXi audio page P2-6.
Back to top
View user's profile Send private message
Lightbringer
Full Member


Joined: 07 Jan 2018
Posts: 211
Location: USA

PostPosted: Wed Nov 20, 2019 2:28 am    Post subject: Reply with quote

Thank you! Good reads and very helpful. I tried a lot of different things. But not those things. Smile

I'll try that and report back.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    Korg Forums Forum Index -> Korg Kronos All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group