Using Input 1 & 2

Stratario · Post by **Stratario** » Thu Mar 05, 2015 5:50 pm

Hi all. My setup if for home use only. I have the output from a Kronos hooked up to the input of my Pa2X. the output from pa2X is hooked up to the monitors. I can hear play and hear both keyboards through the monitors and at the same time I can record both on the Mp3 recorder of Pa2X.

Now I am adding one more piece. I have hooked up the output from a new Roland Integra 7 to inputs 1 & 2 of the Kronos. I am playing the demo sound on the Integra. I was hoping that the Kronos would pass it audio inputs 1 & 2 directly to its out, which in turn is going to the Pa2X. But no sound is coming from the Integra to the monitors. I have pushed the buttons next to the input jack down and set them to "Line".

So what do I have to do to make the Kronos pass the two inputs directly to its outputs. Later on I might want to use some sounds from the Integra in the Kronos combies.

Your help would be much appreciated. Thanks.

Fred

Mighty_Ferguson · Post by **Mighty_Ferguson** » Thu Mar 05, 2015 6:01 pm

You need to change the bus select to either L&R (or one of the other audio outputs) to directly route the audio back out, or to one of the IFX slots to add an effect. You can either do this globally, or per program/combi.

Stratario · Post by **Stratario** » Thu Mar 05, 2015 6:17 pm

Mighty_Ferguson wrote:You need to change the bus select to either L&R (or one of the other audio outputs) to directly route the audio back out, or to one of the IFX slots to add an effect. You can either do this globally, or per program/combi.

Awesome. I set the Bus Select to L/R and bingo, I got sound. Thanks a lot.

Fred