Third Party Volume Pedal

rex888 · Post by **rex888** » Sat Jan 19, 2013 3:26 pm

I have a PROEL Volume pedal and have this issue since I got my Triton.

The sensitivity of this pedal is too high. So it jumps from value 0-127 in about 25% of the pedal position.

I have tried this pedal with my Roland or M-Audio keyboards and it worked as normal.

Does anyone know how to adjust the sensitivity from Kronos? Or should I use only Korg official pedals?

Or perhaps any other brands that are compatible with Korg standard?

SanderXpander · Post by **SanderXpander** » Sat Jan 19, 2013 5:43 pm

Different manufacturers use different voltages. But Korg and Yamaha are the same. Most players on here seem to prefer the Yamaha FC-7 over the Korg alternative. I certainly do, I have two and they're excellent. They work across the full range of the Korg keyboards.

rex888 · Post by **rex888** » Sat Jan 19, 2013 6:17 pm

thanks

.Jens · Post by **.Jens** » Sun Jan 20, 2013 2:56 pm

SanderXpander wrote:Different manufacturers use different voltages. But Korg and Yamaha are the same. Most players on here seem to prefer the Yamaha FC-7 over the Korg alternative. I certainly do, I have two and they're excellent. They work across the full range of the Korg keyboards.

It's not really the voltage, but the pin assignment. If it's a version with detachable cable, you coud try swapping tip and ring on one end of the cable... This worked for me with a Boss pedal, which also showed exactly the behaviour you described, when I first used a standard 1:1 TRS cable.

Sparrow · Post by **Sparrow** » Sun Jan 20, 2013 3:06 pm

What about a Behringer FB1010? Volume pedal is perfectly linear, and the pedalboard can do so much more.

countrycreek · Post by **countrycreek** » Sun Jan 20, 2013 9:18 pm

try ashby solutions they have a adapter that lets you interchange korg and roland volume pedals it's called fc7 foot pedal adapter