No Sound From Middle C down (Korg Triton Pro)

Discussion relating to the Korg Triton Classic.

Moderators: Sharp, X-Trade, Pepperpotty, karmathanever

Post Reply
knewbie
Posts: 1
Joined: Wed Jun 30, 2010 1:17 am

No Sound From Middle C down (Korg Triton Pro)

Post by knewbie »

Hi all, I'm a newbie. I've gone through the threads but haven't found the answer to this yet. Whenever I turn on my Triton the sound from C# and above comes out when played but the sound from C and below whenever comes on. Is there something I could do?

Thanks
User avatar
McHale
Platinum Member
Posts: 2487
Joined: Tue Feb 10, 2009 4:03 pm
Location: B.F.E.

Post by McHale »

What I would do is turn it over and remove all of the screws. The bottom will lift off. You will easily see a couple system boards and some cables that plug into them. I'd just push them all down and make sure they are secure.

REMEMBER TO POWER OFF AND UNPLUG THE UNIT FIRST!!!!

Good luck!
Current Korg Gear: KRONOS 88 (4GB), M50-73 (PS mod), RADIAS-73, Electribe MX, Triton Pro (MOSS, SCSI, CF, 64MB RAM), SQ-64, DVP-1, MEX-8000, MR-1, KAOSSilator, nanoKey, nanoKontrol, 3x nanoPad 2, 3x DS1H, 7x PS1, FC7 (yes Korg, NOT Yamaha).
User avatar
mikemolloyuk
Moderator
Posts: 748
Joined: Wed May 23, 2007 9:22 am
Location: Milton Keynes, UK

Post by mikemolloyuk »

Hi

The keyboard is split into two sections so the chances are that it is just the ribbon cable that is disconnected or crimped on something on the inside causing loss of signal in the cable.

Mike
Mike Molloy

Ex Korg UK Technical Support 2002 - 2010

Forum Moderator since 2011


When Words Fail, Music Speaks
Post Reply

Return to “Korg Triton Classic”