Korg Forums

I use cubase as my sequencer after i lay down the basis of my song in my triton. After i save my sng to a standard midi file, i send it to cubase, however, what setting would allow me to change the volume, or effect intensity, etc... because the volume and other settings reset every time i stop and start the song again. I know that in the triton i can change these settings by using create or erase control data but it does not change in cubase. Any help?? thanks, mattyc

You have to erase the control data in cubase as well
Ctrl-G takes you too the page were you erase the data.