midi question

[mattyc]

I use cubase as my sequencer after i lay down the basis of my song in my triton. After i save my sng to a standard midi file, i send it to cubase, however, what setting would allow me to change the volume, or effect intensity, etc... because the volume and other settings reset every time i stop and start the song again. I know that in the triton i can change these settings by using create or erase control data but it does not change in cubase. Any help?? thanks, mattyc

[Bazz02]

You have to erase the control data in cubase as well
Ctrl-G takes you too the page were you erase the data.