Page 1 of 1
BUG with RADIAS when switching sounds ? .... help !
Posted: Wed May 14, 2008 6:26 pm
by hoooray
hi ...
when i turn on the radias and play with sounds . the proram jump to the I:01 bank and when i try to go back to A:01 bank its not work ...
the program skip over the A . B . C bank....
its just my radias or what?
please its frusrating me
Re: BUG with RADIAS when switching sounds ? .... help !
Posted: Wed May 14, 2008 9:25 pm
by meatballfulton
hoooray wrote:when i turn on the radias and play with sounds . the proram jump to the I:01 bank and when i try to go back to A:01 bank its not work ...he program skip over the A . B . C bank....
Are you switching programs from the front panel or via MIDI? To get from banks A-H to banks I-P (or the reverse) via MIDI you have to send a bank select as well as a program change.
You should be able to scroll through all 256 patch locations using the data wheel.
Posted: Thu May 15, 2008 6:03 am
by hoooray
Are you switching programs from the front panel or via MIDI?
im switching the sounds with the program value wheel of radias.
i notic that when im switch sounds by category {leed base etc..}
its work fine and not jump to I bank....
what is that ?
Posted: Thu May 15, 2008 1:58 pm
by dr_boehm
Hi hooray,
i had a defect wheel so program switching was a bit random when i was turning the wheel.
I had the radias for repair and after that all is ok now!
Ciao, Dirk.
Posted: Fri May 16, 2008 5:55 am
by hoooray
mmmmmmmmmmm so its a defect
thanks for the help
Posted: Sat May 17, 2008 2:59 pm
by hoooray
well .... i found what the problem is !
its not a RADIAS bug ... its the sequencer that i use Cubase SX3 .
if anyone know this bug and have a solution for it . it will be cool.
Posted: Sat May 17, 2008 6:32 pm
by Friendo
I've noticed it. It happens to me when I scroll too fast. When I slow down between banks, say from A16 to B01, it will make the jump proper. Also using the buttons can get me to the banks, then scroll from there.