BUG with RADIAS when switching sounds ? .... help !

[hoooray]

hi ...

when i turn on the radias and play with sounds . the proram jump to the I:01 bank and when i try to go back to A:01 bank its not work ...

the program skip over the A . B . C bank....

its just my radias or what?

please its frusrating me

[meatballfulton]

when i turn on the radias and play with sounds . the proram jump to the I:01 bank and when i try to go back to A:01 bank its not work ...he program skip over the A . B . C bank....

Are you switching programs from the front panel or via MIDI? To get from banks A-H to banks I-P (or the reverse) via MIDI you have to send a bank select as well as a program change.

You should be able to scroll through all 256 patch locations using the data wheel.

[hoooray]

Are you switching programs from the front panel or via MIDI?

im switching the sounds with the program value wheel of radias.

i notic that when im switch sounds by category {leed base etc..}
its work fine and not jump to I bank....

what is that ?

[dr_boehm]

Hi hooray,

i had a defect wheel so program switching was a bit random when i was turning the wheel.

I had the radias for repair and after that all is ok now!

Ciao, Dirk.

[hoooray]

mmmmmmmmmmm so its a defect

thanks for the help

[hoooray]

well .... i found what the problem is !

its not a RADIAS bug ... its the sequencer that i use Cubase SX3 .

if anyone know this bug and have a solution for it . it will be cool.

[Friendo]

I've noticed it. It happens to me when I scroll too fast. When I slow down between banks, say from A16 to B01, it will make the jump proper. Also using the buttons can get me to the banks, then scroll from there.