hi all

Discussion relating to the Korg Pa1X / Pa1Xpro

Moderators: Sharp, X-Trade, Pepperpotty, karmathanever

Post Reply
robertocarlo
Full Member
Posts: 245
Joined: Mon Mar 05, 2007 4:23 am
Location: mexico

hi all

Post by robertocarlo »

Hello everyone .. Two questions ... 1). Does that capacity hard disk. Used for pa1x ...80/100/ question .2). The distance from my town to the service center. I am in need to send a technician to fix Local my p1x ... key (A key index Central) does not sound insurance is dirty the key... - Does anyone have experience with this ?....best regards..
it imagines to all people living peacefully
Reuben
Platinum Member
Posts: 1619
Joined: Wed Jan 31, 2007 3:51 am
Location: Sydney, Australia
Contact:

Post by Reuben »

Hi,
For Q2 - I have watched an authorised Korg repair tecnichian fix the dirty contact problem on my Pa1xpro and its not too difficult.
The whole keybed comes out easily after you remove about 16 screws from the back. But you need to be carefull that you dont break anything when disconnecting the wire bundle/ribbon to allow you to move the keybed well away from its position.
Just peel off the rubber contact velocity strips near the key that is a problem (each rubber strip does about 12 keys) and clean the contact area (usually with air).
Its best to put the strip back by poking it with a paperclip (dont use a pin it is too sharp).
If there is someone who can translate this for roberto - it might be helpful.
Best,
John
robertocarlo
Full Member
Posts: 245
Joined: Mon Mar 05, 2007 4:23 am
Location: mexico

ok . reuben ¡¡ very well¡¡

Post by robertocarlo »

REUBEN thank you very much. If grasped. I am using the language translator google .... Very well. I´m and a friend technicisian. and clean. :lol: the pa1x .... Thanks reuben best regards
it imagines to all people living peacefully
Post Reply

Return to “Korg Pa1X - Pa1Xpro”