Hello again. Sequencer Track-Edit stuff, this time.
Example, I have repeated a 4-bar drum pattern several times to cover verse and chorus. This pattern has notes of varying loudness (velocity).
What is the easiest way (or any way) of increasing the velocities for the pattern in the chorus to make it louder?
Essentially, is there a way to add N to the velocities of all notes between bar X and bar Y in one job lot without having to modify each individually?
Modifying chunks of sequenced data
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
UPDATE
OK. So I think I was using the Modify Velocity function before but hadn't thought it through. This might work...
To make all notes a bit louder I set Curve to 1 (a straight line) and the Start and End both to 127 (max). The tricky part is the INTensity which would not change anything if set to 0% and would set everything to 127 if it were at 100%.
I set this to 20% and it seems to have worked but I'm guessing that it serves to move all velocities 20% of the way to 127 rather than moving all notes up equally as I would prefer.
Has anyone got any better ideas?
OK. So I think I was using the Modify Velocity function before but hadn't thought it through. This might work...
To make all notes a bit louder I set Curve to 1 (a straight line) and the Start and End both to 127 (max). The tricky part is the INTensity which would not change anything if set to 0% and would set everything to 127 if it were at 100%.
I set this to 20% and it seems to have worked but I'm guessing that it serves to move all velocities 20% of the way to 127 rather than moving all notes up equally as I would prefer.
Has anyone got any better ideas?