Volca Keys in DAW with midi sync strange beeping noise

[Pedr]

I have my volca keys connected up to my audio interface via a 3.5mm jack and a midi cable.

Once i set up the midi sync from logic to the Volca keys and press play it makes a strange beeping sound different to anything I may have saved in the volca's memory, now even if I press pause in logic and pause on the volca the sound still persists.

I can adjust how frequent the beep is by adjusting the rate knob and its cutoff on the volca but when i play anything it sounds completely different to this beep and it interferes with anything I've got saved.

I have no problem when I start up the volca and press play without the midi cable connected but obviously I want it for the sync. I've tried the factory reset on the volca but still the problem persists. Anyone got an idea to why this is?

[Butterfingersbeck]

Silly question perhaps, but do you have the metronome enabled? The on/off setting is saved with each sequence. Select the sequence you want to use, switch off the metronome and save it again.