PA 700 ist tremolo möglich?

[Elsensee]

Hallo Forum,
für die Klangfarbe/Sound > Warm Steel < möchte ich gerne ein Tremolo aktivieren.
Ich finde es nicht in den Einstellungen, meine aber, es schon einmal irgendwo gesehen zu haben.

Wer kann mir da helfen und sagen wo diese Einstellung aufrufbar ist?
Danke sagt Elsensee

[siebenhirter]

.. für die Klangfarbe/Sound > Warm Steel <möchte> Joystick/Pedal page and use the Joystick Y checkbox to to turn on /off on each keyboard sound (lower, upper1-3)...

If factory sound "Warm Steel" is made without modulation, it is possible to add effects (Stereo Tremolo, St. Env. Tremolo, Classic Tremolo) to a track that using that sound.

Or you decide to learn how to use the Sound Editor to add LFOs to this sound. LFO (Low Frequency Oscillation) can be used to cyclically modulate the Pitch, Filter, and Amp of each oscillator.

[Elsensee]

Danke siebenhirter,
ich hatte das schon geahnt, denn irgendwo hier im Forum habe ich gelesen, dass ein Tremolo über Effekt 52 möglich sei.
Dann werde ich mich mal mit chapter 45 anfreunden müssen...
Bei einem meiner gehabten keybords war ein Tremolo möglich durch Hinzunahme einer 2. oder 3. harmonischen Taste möglich, entweder EK50 oder PSR 620.
Ich danke dir mit besten Grüßen nach Siebenhirten.
Elsensee

[siebenhirter]

.. mit chapter 45 anfreunden ... Tremolo möglich durch Hinzunahme einer 2. oder 3. harmonischen Taste möglich, entweder EK50 ...

When selected, effects are assigned to a sound/channel with its default parameters; a sound selected will be loaded with individual effect parameters if it was saved. These parameters, which can be changed for customization, are described in Chapter 45.

Beforehand, however, it should be noted, that Master effects (MFX) can be mixed in different levels, but are shared by several different Sounds of a group.

If you turn on/off the master effect(s), you should keep in mind that master effects are assigned to all the Sounds of the same group.
That means if you assign a master effect (any of tremolo) to Upper1 (FX group B, Master FX1 or FX2), also Upper2, Upper3, Lower are assigned to that tremolo.

The send level (direct/dry signal sent to master effect) from each Sound/channel is adjustable separately.
With group of keyboard sounds Upper1 has priority when changing FX1/2 of FX group B.
*
EK50-effects: With this, each keyboard set could be processed with two different effects (effect 1/2). As a "default" you get a factory-optimized effect for the keyboard set. The effect level was set with "Effect Send".

[Elsensee]

Thanks siebenhirter, yesterday I did adjust some parameters beginning page 611, I got an effect, but real pleased it isn't, at now, there are so many opportunities to srew and turn on. I'll keep on...
Tomorrow I can put hands on my EK50 testing the tremolo effect.
Best regards