Hi there
Newbie question. Been trying to work this out for many hours.
When I try to make a new sound under Init Performance going onto Layer A and changing default wave sequence to Single Multisample and then selecting any sound eg a piano the volume is stuck at 100% even if I slightly tap the keyboard. Velocity sensitivity has disappeared from the multisample. I'm not talking about the sample changing to another sample via velocity but rather midi velocity data won't work on it. When I play around with preset performances or programs velocity changes are there and work fine.
Please help.
Single Multisamples stuck at 100% volume when imported
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
-
- Posts: 5
- Joined: Mon May 10, 2021 12:22 pm
- QuiRobinez
- Approved Merchant
- Posts: 2562
- Joined: Sat Aug 25, 2007 10:08 am
- Location: Netherlands
- Contact:
when you select an init performance then the velocity parameter is set to zero, that makes sense, because you are going to program your own sound with your decisions about the behavior of that sound.
If you want to add velocity control to your sound just press:
- Amp envelope button
- turn the velocity knob in the envelope section
i've created a set of tutorials that explains how to program the wavestate. See:
http://www.korgforums.com/forum/phpBB2/ ... p?t=124833
If you want to add velocity control to your sound just press:
- Amp envelope button
- turn the velocity knob in the envelope section
i've created a set of tutorials that explains how to program the wavestate. See:
http://www.korgforums.com/forum/phpBB2/ ... p?t=124833
-
- Posts: 5
- Joined: Mon May 10, 2021 12:22 pm