Assigning Parameters to the 5 control knobs on MicroKorg

[Toon Bosch]

Hey,

This is probably a really basic question but I can't figure out how to assign different parameters to the 5 control knobs on my MicroKorg. When you load up a program the knobs are by default assigned to 1. Cutoff 2. Resonance etc. But how can you assign, for example the transpose parameter to knob 1 and the delay time to knob 2 (or any other parameter). Is this even possible?

Thanks in advance!
Regards,
Toon

[OpAmp]

Hi,

It is not possible to reassign parameters to the knobs.

Of course, you could go into edit mode and select a row in the matrix, while you perform. But this typically edits parameters that are related.

Have fun.