NanoKontrol 2, No LED in Mackie Mode

trifty · Post by **trifty** » Mon Apr 30, 2018 4:39 pm

So I just picked up the nanokontrol 2 today and am struggling to get the LEDs to work with Studio One!

Instructions on Studio One says to plug in the kontrol while holding SET and REW which works well for all the buttons. But it totally disables ALL the LEDs on the controller except for the power led.

Any ideas guyys

?

voip · Post by **voip** » Mon Apr 30, 2018 6:31 pm

The Korg MIDI drivers need to have been installed before the nanoKontrol was plugged in for the first time.

.

trifty · Post by **trifty** » Tue May 01, 2018 4:38 am

voip wrote:The Korg MIDI drivers need to have been installed before the nanoKontrol was plugged in for the first time.

.

Thanks for the reply! Hmm but I did install the drivers on Windows but it didn’t make a difference to the LEDs

trifty · Post by **trifty** » Tue May 01, 2018 4:44 am

Oh Finally figured it out! I didn't set the SEND to the Korg but only the RECEIVE from. Works now!

voip · Post by **voip** » Tue May 01, 2018 1:02 pm

trifty wrote:Oh Finally figured it out! I didn't set the SEND to the Korg but only the RECEIVE from. Works now! :D

Excellent. Pleased to hear it.

.