SQ-1 MIDI din mod?

hjulskov · Post by **hjulskov** » Tue Apr 19, 2016 6:37 am

Hi

I'm considering buying a second-hand SQ-1 without the MIDI din cable.

Does anyone know if it is possible to add a standard din socket for MIDI out on the SQ-1?
If there is room it should just be to solder it to the pcb where the mini-jack is soldered -or?

Also does anyone know the diagram of the SQ-1 MIDI din cable?

Thank you so much

frenchkisz · Post by **frenchkisz** » Sun Apr 24, 2016 2:34 pm

check the pin with a cheap volt meter, you will get a correct answer !

hjulskov · Post by **hjulskov** » Fri Apr 29, 2016 7:58 am

frenchkisz wrote:check the pin with a cheap volt meter, you will get a correct answer !

Thanks, but the problem is that I don't have the original midi cable included with the SQ-1

frenchkisz · Post by **frenchkisz** » Sat Apr 30, 2016 3:14 pm

Mini jack TRS To Front DIN Female :

Sleeve-----------Center upper Pin.
Ring--------------Left upper Pin.
Tip----------------Right upper Pin.

(opposite side for DIN Male connector)

done!

hjulskov · Post by **hjulskov** » Mon May 02, 2016 6:43 am

frenchkisz wrote:Mini jack TRS To Front DIN Female :

Sleeve-----------Center upper Pin.
Ring--------------Left upper Pin.
Tip----------------Right upper Pin.

(opposite side for DIN Male connector)

done!

Thanks a lot!