Hey there,
I'm using a Kaossilator pro and the Behringher FCB1010 to trigger the 4 sample banks and the expression pedals to control the X and Y axis on the touch pad.
This all works fine, however the touch pad is always on, is there a way to program the FCB1010 to switch the touch pad on and off?
I use it in a live set whilst playing guitar but as the touch pad is always on it means turning the volume down on the pad until I need it again, would be easier if I could switch it on and off!
All help appreciated!!
Korg Kaossilator pro and Behringher FCB1010
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
-
spooncore@yahoo.co.uk
- Posts: 3
- Joined: Sat Mar 26, 2016 8:09 pm
Hi,
Mmh, you may set up your Behringer to control (toggle) the volume between 0 and e.g. the maximum value (CC#94) at the moment you press a preset button. (It basically overrules volume knob setting). There is also the CC#92 which turns on/off the touch pad.
Maybe you need to rework as well your other presets that trigger the samples and X/Y to combine it with volume/touchpad on/off. That depends a bit on how your current setup exactly works.
Bye.
Mmh, you may set up your Behringer to control (toggle) the volume between 0 and e.g. the maximum value (CC#94) at the moment you press a preset button. (It basically overrules volume knob setting). There is also the CC#92 which turns on/off the touch pad.
Maybe you need to rework as well your other presets that trigger the samples and X/Y to combine it with volume/touchpad on/off. That depends a bit on how your current setup exactly works.
Bye.
microKORGXL, Kaossilator Pro, monotribe, SQ-1, volca fm, Kross 88 BK
Alesis SR18, Akai Miniak, Fender Strat, Line 6 Spider II 112, Zoom MS-50G
Alesis SR18, Akai Miniak, Fender Strat, Line 6 Spider II 112, Zoom MS-50G