MS-20 Legacy controller - LFO always on

Ortac · Post by **Ortac** » Sun Oct 11, 2015 6:44 pm

Hi everyone,
Hopefully somebody will have an answer to my problem...

I today set up the MS-20 controller, and after eventually working out how to activate the software, I managed to start tinkering.

I could flick through the presets and then realised that I can turn the volume knob on to initialise the patch as per the actual controller.

So far so good, until I realised that the Modulation Generator seems to permanently affect the pitch of the sound. All of the leads are unplugged from the matrix, but no matter what I seem to do, the pitch, and volume always wobble. I can delay it a bit with EG1, but that only seems to delay the pitch wobble, the volume still gets modulated.

Part of me thinks I am missing something obvious, but I'm pretty sure something is not working right.

Installed on Windows 10, the standalone and vst both have the problem.

Any ideas would be much appreciated
Thanks everyone

Darren

Ortac · Post by **Ortac** » Mon Oct 12, 2015 8:59 pm

I worked out what was happening... it was me being daft of course!

When turning the volume up to reset the patch... there is an additional on-screen only set of parameters in the Edit section that do not get initialised, and stay set to however they were in the preset.

These were causing the wobble.