ELECTRIBE 2 MIDI OUT
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
ELECTRIBE 2 MIDI OUT
I trying to use the electribe 2 as a midi controller. I am trying to midi map parameters with the knobs on the device for ableton and resolume. The device only sends two distinct message 1/32 and 1/0, which is of little use. Is there any way to use this device as a controller?
Hey, I am not sure but did you try the usb connection to your computer?
This should work quite well. I could see every MIDI signal that is listed on the MIDI Implementation Chart on page 65 of the E2 manual
(get it here: http://i.korg.com/uploads/Support/USA_E ... anual2.pdf)
You can select the MIDI Channel and what signals to filter in your Electribes Global settings (24/26 -> 5, 6 and 7/17)
If you're on a mac you can check out MidiMonitor to see what the E2 spits out.
This should work quite well. I could see every MIDI signal that is listed on the MIDI Implementation Chart on page 65 of the E2 manual
(get it here: http://i.korg.com/uploads/Support/USA_E ... anual2.pdf)
You can select the MIDI Channel and what signals to filter in your Electribes Global settings (24/26 -> 5, 6 and 7/17)
If you're on a mac you can check out MidiMonitor to see what the E2 spits out.