SQ1 Gate vs. Sync polarity?

mantrak · Post by **mantrak** » Sun May 24, 2015 1:50 pm

Has anyone noticed that the Owner's Manual describes exactly the same procedure for setting Sync and Gate polarity? In both cases it is controlled by MODE button, which is... uhm... looks like obvious error to me.

Steve GG · Post by **Steve GG** » Tue Jun 02, 2015 8:47 pm

Yes I have noticed this. The procedure using the MODE button does certainly change the TRIG/GATE polarity. I'm not sure that it changes the SYNC polarity at the same time - would that even make sense?

Either there's another button to push when setting SQ-1 global parameters (can't see one lit up) or it isn't possible to change SYNC polarity.

Steve GG · Post by **Steve GG** » Wed Jun 03, 2015 9:12 pm

I've mentioned this to Korg tech support as an aside to an unrelated problem I'm having with the SQ-1. I'll post any relevant responses from Korg here.

Epignosis567 · Post by **Epignosis567** » Sun Aug 16, 2015 7:15 pm

So does anyone know what the duty/function button does when you're in global parameters settings? You can turn it on/off but I can't figure out what effect it has and Korg doesn't mention it in the manual anywhere...

gondar5678 · Post by **gondar5678** » Fri Jan 29, 2016 10:19 am

Waiting for answers
บาคาร่าออนไลน์มือถือ

frenchkisz · Post by **frenchkisz** » Mon May 02, 2016 7:14 am

Hi,
When u change the parameter setting for Gate (+/-), at the same time u also change the sync inout polarity. probably both are linked with the function !