saving Pad-Settings within a combination

MigL81 · Post by **MigL81** » Mon Nov 30, 2009 11:38 am

Hi Folks,

(sorry for my english

)

I have a problem using the pads in combi-mode

I programmed a combination where I also use the Pads. No problem so far.
But: after saving the edited combination the pad assign I used for this combi is also saved in ALL the other combinations. By changing the pad assign in one combi, the pad-assign in all the other combinations are also changed.
programm-mode runs without any problems.

What is this for an error ? Does somebody have a solution ??

thx & regards,

Miguel

jg:: · Post by **jg::** » Mon Nov 30, 2009 11:51 am

Hi Miguel,

I think that the pad settings are part of Karma. Gto the first page in Global mode, and in the top RH side, there's a Karma section. Check that "Load Karma settings when changing Combi" is checked. Then save Global data in the menu [very top RH corner].

jg::

MigL81 · Post by **MigL81** » Mon Nov 30, 2009 1:05 pm

Hi jg::

that's it

Thank you !