Route each oscillator to separate FX paths in Program?

pizzafilms · Post by **pizzafilms** » Wed Feb 04, 2015 8:22 pm

Is this possible?

I want to have a Program with 2 AL-1's and they each go through separate fx paths not summed together until after.

I can't figure out a way without making it a Combi which I don't want to do for other reasons.

Thanks.

SanderXpander · Post by **SanderXpander** » Wed Feb 04, 2015 9:50 pm

Can't be done.

Bald Eagle · Post by **Bald Eagle** » Thu Feb 05, 2015 12:39 pm

Not sure if this would work and it is a bit limiting but I think you could use the "OSC MFX Send" Parametes to route osc 1 to MFX 1 and OSC 2 to MFX 2. At least you should get one FX per OSC.