How to setup the OASYS's control surface to control Kronos

Discussion relating to the Korg Oasys Workstation.

Moderators: Sharp, X-Trade, Pepperpotty, karmathanever

Post Reply
User avatar
narf
Approved Merchant
Approved Merchant
Posts: 369
Joined: Tue Jan 01, 2008 3:39 pm
Location: Melbourne, Australia

How to setup the OASYS's control surface to control Kronos

Post by narf »

I've tried mapping the control surface in external mode of the OASYS to match the CC#s of the buttons and sliders of the Kronos but no changes occur when I move them. I was hoping to use the sliders as drawbar controls in CX3 programs and general editing. Is it even possible to match the 2 up this way?
Admin Kronos Enthusiast Workshops Facebook Group
Korg Kronos SE 61, Kronos 2 88 Gold, Oasys-88, Triton Studio76, Kronos-61, SV1-73RV, Prologue 16, OpsixSE
www.narfsounds.com
User avatar
StephenKay
KARMA Developer<br>Approved Merchant
KARMA Developer<br>Approved Merchant
Posts: 2995
Joined: Tue Jun 18, 2002 2:16 am
Location: Scottsdale, AZ
Contact:

Post by StephenKay »

I would think it should be possible.

Have you tried making sure the Kronos is set to respond to incoming CCs for the various sliders and buttons in the Global > MIDI > Controllers page?
Post Reply

Return to “Korg Oasys”