Page 1 of 1
How to activate TONE ADJ/EQ in Cubase6.5
Posted: Wed Jan 01, 2014 9:51 am
by Big Bear
After longer time I discovered that the knob "tone adj/eq" was not working because of midi send out/in to and from cubase.
How do I have to change the setup in Korg Kronos to make it work.
Or do I have to change settings in the DAW (Cubase 6.5)
Thanks for your help!
Posted: Wed Jan 01, 2014 12:56 pm
by Niarf
Do you want that the Kronos displays the Tone adjust page with a message sent by Cubase ?
Using midiox, there should be a midi message revealed, but I don't if this message exists... I will try this, my set is gigged, I must tidy all ^^
Posted: Wed Jan 01, 2014 2:32 pm
by Big Bear
I would like to turn the knobs on Kronos so that Kronos reactie as it should.
With midi kabels connected to the computer/cubase, the kronos doesn't react when "tone adj" is activated.
Thanks a lot for your suggestions!!!
Posted: Wed Jan 01, 2014 5:22 pm
by Niarf
I have launched midi ox, it reacts at each moving knob, so if you have a midi learn on an enveloppe in cubase, assign it and make the enveloppe pilot the sysex of the knob =)