How to activate TONE ADJ/EQ in Cubase6.5

Big Bear · Post by **Big Bear** » Wed Jan 01, 2014 9:51 am

After longer time I discovered that the knob "tone adj/eq" was not working because of midi send out/in to and from cubase.

How do I have to change the setup in Korg Kronos to make it work.
Or do I have to change settings in the DAW (Cubase 6.5)
Thanks for your help!

Niarf · Post by **Niarf** » Wed Jan 01, 2014 12:56 pm

Do you want that the Kronos displays the Tone adjust page with a message sent by Cubase ?

Using midiox, there should be a midi message revealed, but I don't if this message exists... I will try this, my set is gigged, I must tidy all ^^

Big Bear · Post by **Big Bear** » Wed Jan 01, 2014 2:32 pm

I would like to turn the knobs on Kronos so that Kronos reactie as it should.
With midi kabels connected to the computer/cubase, the kronos doesn't react when "tone adj" is activated.
Thanks a lot for your suggestions!!!

Niarf · Post by **Niarf** » Wed Jan 01, 2014 5:22 pm

I have launched midi ox, it reacts at each moving knob, so if you have a midi learn on an enveloppe in cubase, assign it and make the enveloppe pilot the sysex of the knob =)