How to Remove Rubber Feet from OASYS Bottom?

Nightowl3272 · Post by **Nightowl3272** » Mon Oct 14, 2013 9:59 am

Surprisingly, I couldn't figure out how to do this...also surprisingly, I didn't see any mention of how do do this by searching here or anywhere else on the web.

Does anyone know of a way to remove the 4 rubber feet from the bottom of the OASYS without pulling all of the boards out from the top?

The feet in my old Triton Classic come out by turning the little plastic screw counter-clockwise and they fall right out. But there's no slot for the screw driver with the OASYS.

Nightowl3272 · Post by **Nightowl3272** » Tue Oct 15, 2013 4:30 am

The more I look at it, the more I realize that the only way is from the top by removing all of the circuit boards.

I wouldn't even bother if 2 of the feet weren't already missing...not sure how no Earth that happened.

I suppose I could use a hacksaw or maybe drill it out...yikes! :-/

Nightowl3272 · Post by **Nightowl3272** » Tue Oct 15, 2013 6:39 pm

Screw the hack-saw, I just squeezed the hell out of em with a pair of pliers and they pulled out pretty easily...

Ill-conceived rubber feet replaced with felt glides...

Mike Conway · Post by **Mike Conway** » Tue Oct 15, 2013 10:11 pm

Pliers - check! Thanks for the update.