Page 1 of 1
Midi output problem
Posted: Fri Apr 20, 2012 1:07 am
by cyrusrua
I can't seem to get any signal out of the midi out. The jack, not the usb. When connected, to my Tascam interface, the light that shows midi signal is lit constantly, but nothing happens when I press the keys. Plugged into my Kurzweil, everything is working, so I know it's not the pc or interface. This thing is driving me nuts, so any help is most appreciated.
Re: Midi output problem
Posted: Fri Apr 20, 2012 7:26 pm
by hewi
cyrusrua wrote:I can't seem to get any signal out of the midi out. The jack, not the usb. When connected, to my Tascam interface, the light that shows midi signal is lit constantly, but nothing happens when I press the keys. Plugged into my Kurzweil, everything is working, so I know it's not the pc or interface. This thing is driving me nuts, so any help is most appreciated.
PA3X
USB or MIDI plug? Read manual page 241 >
http://korg.com/uploads/Support/Pa3X%20 ... 050000.pdf
http://www.korgpa.com/it/support/produc ... nuals.html
http://www.korgpa.com/it/support/produc ... tware.html
Posted: Fri Apr 20, 2012 7:54 pm
by cyrusrua
Kronos, not the PA3X. And with a midi plug, not the usb.
Posted: Sat Apr 21, 2012 2:15 am
by jeremykeys
I don't know. Mine works fine. Could this be channel related?
Posted: Sat Apr 21, 2012 3:18 am
by cyrusrua
I don't think so. I think I'm set on channel 1 & the patch is as well. Like I said, the light on the Tascam that lights when receiving midi data is lit continuously as if I was doing a data dump.
Posted: Sat Apr 21, 2012 3:35 am
by jeremykeys
Wish i could help you. Sorry but I have no idea.
Posted: Sat Apr 21, 2012 9:22 am
by X-Trade
The light may light continuously because of active sensing data. There is nothing wrong with that.
Not sure why it wouldn't be working though - check your MIDI note filter in global mode?
Posted: Sat Apr 21, 2012 10:13 am
by SoundsOfPlanet
Check it :
Seq Mode -
Set the channel 1 -
on the bottom tab "track parameter" set BTH
Must be a midi signal