From time to time the screen and controls go crazy like I'm scrolling through everything as fast as I can. It changes all of that screens settings randomly. It's driving me crazy.
Anyone having this problem??????
Peace
D3200 display going haywire!!!!!!
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
Same as
Hi,
Yep,
I'm having exactly the same problem which is extremely frustrating. Did you figure out what was causing it? I hope it's not static, a CMOS problem or something similar, presuming they have a CMOS ????
Anyone else know anything regards this?
Cheers
Yep,
I'm having exactly the same problem which is extremely frustrating. Did you figure out what was causing it? I hope it's not static, a CMOS problem or something similar, presuming they have a CMOS ????Anyone else know anything regards this?
Cheers
RE: D3200 display going haywire!!!!!!
Hi all,
i have same problem at my first attempts...
This problem occurs when the D3200 is taken from a cold environment to a warm environment. Atmospheric moisture condenses here on cold surfaces (here on PCB boards) and cause leakage between the printed wires and soldered points. It is VERY IMPORTANT when such a transition from a cold to a warm environment to allow equalization of temperature WITH POWER OFF!!!
(Pls, excuse my terrible English
i have same problem at my first attempts...
This problem occurs when the D3200 is taken from a cold environment to a warm environment. Atmospheric moisture condenses here on cold surfaces (here on PCB boards) and cause leakage between the printed wires and soldered points. It is VERY IMPORTANT when such a transition from a cold to a warm environment to allow equalization of temperature WITH POWER OFF!!!
(Pls, excuse my terrible English