Page 1 of 1
Reason and Padkontrol
Posted: Sun Nov 16, 2008 1:07 pm
by Mattyoak
Ok so I am trying to assign the XY pad in reason to midi notes so I can control the 2 parameter of a synth. However, I can't work out how to map the Y axis, the X axis always takes priority...
Any ideas?
Posted: Mon Nov 17, 2008 8:18 am
by Ruso
not sure if this is possible in reason but take another midi controller and send an identical message with it as the y axis.... It's possible in ableton and should be in reason.
Me too
Posted: Thu Nov 20, 2008 4:42 am
by kspssd
I just sent off a note to Korg Support telling them my Knob 1 didn't work. Only to realize that ..apparently the module in REASON will only accept 1 control knob. I had it "learn" from the surface. Each time I would alternate from Knob 1 to 2. and each time it would ask to "overwrite" the previous .
Is there a way to get BOTH knobs working???
Re: Me too
Posted: Sun Nov 23, 2008 2:37 pm
by Mattyoak
kspssd wrote:I just sent off a note to Korg Support telling them my Knob 1 didn't work. Only to realize that ..apparently the module in REASON will only accept 1 control knob. I had it "learn" from the surface. Each time I would alternate from Knob 1 to 2. and each time it would ask to "overwrite" the previous .
Is there a way to get BOTH knobs working???
One knob on midi channel 1
One knob on midi channel 2
Posted: Sat Jan 31, 2009 2:16 pm
by tschubiza
Both knobs are working in reason. Just assign them for what you need them.
1. in editor for pad kontrol adjust the cc value
or
2. in reason overide the mapping for ever you need