Reason and Padkontrol

Discussion relating to Korg Controller products.

Moderators: Sharp, X-Trade, Pepperpotty, karmathanever

Post Reply
Mattyoak
Posts: 8
Joined: Fri Oct 24, 2008 4:12 pm

Reason and Padkontrol

Post by Mattyoak »

Ok so I am trying to assign the XY pad in reason to midi notes so I can control the 2 parameter of a synth. However, I can't work out how to map the Y axis, the X axis always takes priority...

Any ideas?
User avatar
Ruso
Platinum Member
Posts: 984
Joined: Sun Feb 11, 2007 11:32 pm
Location: Sammamish, WA
Contact:

Post by Ruso »

not sure if this is possible in reason but take another midi controller and send an identical message with it as the y axis.... It's possible in ableton and should be in reason.
kspssd
Posts: 16
Joined: Thu Nov 20, 2008 4:35 am
Location: San Diego,CA

Me too

Post by kspssd »

I just sent off a note to Korg Support telling them my Knob 1 didn't work. Only to realize that ..apparently the module in REASON will only accept 1 control knob. I had it "learn" from the surface. Each time I would alternate from Knob 1 to 2. and each time it would ask to "overwrite" the previous .
Is there a way to get BOTH knobs working??? :?:
Mattyoak
Posts: 8
Joined: Fri Oct 24, 2008 4:12 pm

Re: Me too

Post by Mattyoak »

kspssd wrote:I just sent off a note to Korg Support telling them my Knob 1 didn't work. Only to realize that ..apparently the module in REASON will only accept 1 control knob. I had it "learn" from the surface. Each time I would alternate from Knob 1 to 2. and each time it would ask to "overwrite" the previous .
Is there a way to get BOTH knobs working??? :?:
One knob on midi channel 1
One knob on midi channel 2
User avatar
tschubiza
Posts: 10
Joined: Sun Dec 23, 2007 10:01 am

Post by tschubiza »

Both knobs are working in reason. Just assign them for what you need them.

1. in editor for pad kontrol adjust the cc value
or
2. in reason overide the mapping for ever you need
Post Reply

Return to “Korg Kontrol49, microKontrol, padKontrol, nano and K series controllers”