Page 1 of 1
Motion sequence aint recording right
Posted: Sat Jan 26, 2008 3:59 am
by musikmachine
Is it a bug?I press motion sequence and record the motion sequence.The record light says on for another 4 measures and the motion sequence doesn't play back as i recorded it,it plays back to front!Any idea why?Don't know what OS i have but i'm sure i updated it when i first got it.The rec light should go out after 8 bars so that must be to do with it.It's like it starts recording the changes 4 bars late
Posted: Sat Jan 26, 2008 1:25 pm
by robosardine
Try saving your data to card. Then do a factory reset. then try reording a motion sequence on a pattern using a metronome count in. Then try one without a count in, What happens then?
Posted: Fri Feb 01, 2008 6:41 am
by musikmachine
robosardine wrote:Try saving your data to card. Then do a factory reset. then try reording a motion sequence on a pattern using a metronome count in. Then try one without a count in, What happens then?
Haven't got round to it yet but i will.I'd like to record the motion sequences and then record the midi patterns into live for further editing(or to audio) instead of having to go trough clip automation(never mind live use!).Hope it's not a fault
Posted: Sat Feb 02, 2008 11:09 am
by inducejack
you from alabama too?????
Posted: Sat Feb 02, 2008 11:46 pm
by musikmachine
inducejack wrote:you from alabama too?????
No other side of the pond
Why?
Posted: Sat Mar 08, 2008 3:10 am
by Setsonics
Damn, I am having this problem, why would it be doing this?
Is it a faulty unit?
It's always done this I think, but I am now getting into more motion sequencing and it records an extra measure after I take off record, PLUS, it bumps the first measure forward one.
Hmm.. I am going to fight with this some more.
Do you really think I need to reset my ESX and test it like that?
I might try... But I got a song to work on,.
=)
Posted: Sat Mar 08, 2008 3:14 am
by Setsonics
Posted: Sat Mar 08, 2008 10:21 am
by musikmachine
Setsonics wrote:Damn, I am having this problem, why would it be doing this?
Is it a faulty unit?
It's always done this I think, but I am now getting into more motion sequencing and it records an extra measure after I take off record, PLUS, it bumps the first measure forward one.
Hmm.. I am going to fight with this some more.
Do you really think I need to reset my ESX and test it like that?
I might try... But I got a song to work on,.
=)
May be a bug as two units are doing the same thing..
I haven't used my MX for a while but was planning to break it out so i think i'll do a reset.I ay be sellig mine so i need to know if this
is a fault or a bug..I hope the latter!
Posted: Sat Mar 08, 2008 12:32 pm
by Setsonics
Well I own an ESX, so it's spread across two models then!
Posted: Sat Mar 08, 2008 4:18 pm
by musikmachine
Setsonics wrote:Well I own an ESX, so it's spread across two models then!
I'll reset mine and see what happens..I'll post the outcome later
Posted: Sun Jan 18, 2009 9:23 am
by starving student
so what happened you two, did you resolve the issue?
Posted: Mon Jan 19, 2009 12:31 am
by Dj Pound
did you try clearing the entire motion sequence, before rerecording your own?
Sometimes i forget to do this and it makes things really difficult.
