Problems with the sound on my ESX-1

Discussion relating to the Korg Electribe products.

Moderators: Sharp, X-Trade, Pepperpotty, karmathanever

Post Reply
StAsmodeus
Posts: 4
Joined: Sat Jul 14, 2012 9:14 pm
Location: Minneapolis MN

Problems with the sound on my ESX-1

Post by StAsmodeus »

Currently I've been having a problem with the sound on my ESX... No matter what output port I am using, I only get sound coming from the right channel. Even while using the headphone port. Is there already another thread that addresses this issue? If so could anyone point me to the right direction? Otherwise I'm stumped...
"Tomorrow never comes until it's too late"
User avatar
robosardine
Platinum Member
Posts: 520
Joined: Wed Oct 03, 2007 8:29 pm
Location: Forfar. Scotland

Post by robosardine »

You may have a faulty tube- you can test this by trying outputs 3&4- they should work fine (as they bypass the tubes). If they do then you will know you have a tube that needs replacing.
StAsmodeus
Posts: 4
Joined: Sat Jul 14, 2012 9:14 pm
Location: Minneapolis MN

Post by StAsmodeus »

Checked out the 3/4 outputs and I get no sound out of either one...
"Tomorrow never comes until it's too late"
StAsmodeus
Posts: 4
Joined: Sat Jul 14, 2012 9:14 pm
Location: Minneapolis MN

Post by StAsmodeus »

Oh good gravy, I was an idiot... I forgot to switch the output bus on each part... Yes it would appear as if I have a tube problem.
"Tomorrow never comes until it's too late"
User avatar
StudioF
Full Member
Posts: 207
Joined: Fri Jul 27, 2007 3:54 am
Location: Netherlands
Contact:

Post by StudioF »

glad to read that your ESX is fine.
Harness the power of Korg synths
Post Reply

Return to “Korg Electribe”