Is there anyway to sync the Radias as master to an Electribe as slave, so when you hit a key on the Radias to start a sequence it triggers a sequence on the Electribe.
I have mine synced up but I have to hit the start button right in time with the Radias to get it to sync together properly.
Syncing the Radias with an Electribe
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
-
thehighesttree
- Platinum Member
- Posts: 594
- Joined: Fri Nov 18, 2011 12:02 am
- Location: Canada East
I only own an R3, but I know it works the other way around: When I hit Stop on the electribe, it kills the arpeggiator on the R3. I think the trick is to set up your MIDI filter so that it allows the stop/start to go through (PCEN filter: you either have to leave C (control) or E (system exclusive) open to transmit this info.
I know this is fairly general, but when you play around with the MIDI filters on your two machines you'll figure it out.
I know this is fairly general, but when you play around with the MIDI filters on your two machines you'll figure it out.