Transposing externally controlled sounds from M50

addy73 · Post by **addy73** » Tue Jun 30, 2009 1:23 pm

I have a combi program that I send a lower key zone to an external keyboard. The problem is that the external keyboard can only be transposed +/- 2 octaves. This sound is an organ and I need it transposed up 1 more octave. Currently the only was I can figure it out is to move the paino patch on the m50 up an octave and map the external organ sound up an octave on the m50 - but I'd rather keep "middle c" in the middle.

Tansposing the sound from the M50 does no good since the sound isn't comming out of the m50.

Is there any way to transpose the external key zone to send midi out notes c4 - c5 instead of c2 -c4 to get around the limitation of the external keyboard?

Thanks!

X-Trade · Post by **X-Trade** » Tue Jun 30, 2009 10:20 pm

I'm pretty sure in COMBI or SEQ mode when you are working with EXT or EXT2 timbres, you should be able to set a transpose amount. I'm assuming that you are playing the organ from the lower half of the M50 keyboard? (wasn't quite clear from your post).

Changing the transpose should change the MIDI value of the notes output.

addy73 · Post by **addy73** » Sat Jul 04, 2009 11:42 am

That worked! Thanks. I don't know what I was doing when I tested the first time.