Chord trigger switches volume

Run · Post by **Run** » Mon Mar 23, 2009 2:46 am

Once chords or else are assigned to these four switches, is there a way to vary their output volume in real time or is it fixed by the velocity value of each note on the chord trigger setup page?

X-Trade · Post by **X-Trade** » Mon Mar 23, 2009 3:00 pm

well they are just part of the MIDI control, so I imagine you need to vary the velocity, but also you can change the mix volume of the timbre(s) that they are controlling. they are just generating MIDI events so there is no real difference between notes triggered from keyboard or the chord pads.

Hobson · Post by **Hobson** » Mon Mar 23, 2009 5:42 pm

You could set on the the four knobs to control expression and set the midi filters so that that knob only controls the volume of the patches being played by the buttons. In this way you can change the volume of the buttons in real time by turning the knob.