creating control data problem

paulshire · Post by **paulshire** » Sat Oct 25, 2008 8:18 pm

Thanks in advance because i can't find answer in manuals. I have used create control data (#7 volume) to 'fade out' the volume (100 down to one) of a horn part i'm using in a song. I've set the data to change for 2 measures only. It works perfectly for the 2 measures HOWEVER the mixer fader stays down at zero for the remainder of the song and i'd like it to return to its' previously un-"data contolled position" for the remainder of the song.

thanks so much
paul

tritex4 · Post by **tritex4** » Sat Oct 25, 2008 11:20 pm

Hello
You basically have to create a new control change to return the
volume back to a previous number, otherwise it will remain at zero.

I would suggest creating a control change at the measure where you
want the volume slider to rise.

paulshire · Post by **paulshire** » Sun Oct 26, 2008 6:55 pm

Thanks Tritex4, it works - sure does seem like a lot of work though.
shortstop