OASYS touchscreen a bit sluggish since the 1.3.0 upgrade

elvisjohndowson · Post by **elvisjohndowson** » Fri Oct 26, 2007 11:17 pm

Hi,
I notice that my OASYS touchscreen is a bit more sluggish to respond to touch commands, since the 1.3.0 upgrade.

Anyone else notice this?

Elvis Dowson

Sina172 · Post by **Sina172** » Sat Oct 27, 2007 6:15 am

...........

domc · Post by **domc** » Sat Oct 27, 2007 6:29 am

No probs for me

danatkorg · Post by **danatkorg** » Sat Oct 27, 2007 7:05 am

I don't think that anything about the touch-screen has changed. Some of the touch-targets are small. If you encounter difficulties, I'd suggest trying to be more deliberate in your touches. If the difficulties persist, I'd suggest carefully re-calibrating.

- Dan

RC-IA · Post by **RC-IA** » Sat Oct 27, 2007 7:37 am

no probs here at this time.

Carbon111 · Post by **Carbon111** » Sat Oct 27, 2007 1:59 pm

My screen is not as sensitive as it was before. What used to take a single push now takes three or so. Is there a calibration routine to fix this?

This is my only issue so far, the rest of the update created no problems...none I've run into anyway.

Sina172 · Post by **Sina172** » Sat Oct 27, 2007 6:15 pm

..........

EJ2 · Post by **EJ2** » Sat Oct 27, 2007 7:13 pm

No problems with touch screen response here either. I usually calibrate my touch screen and trigger pads from Global mode pull down menu (described about) after an OS update anyway.
Cheers,
Eric

steve m · Post by **steve m** » Sun Oct 28, 2007 9:07 pm

After installing V1.3 I had to recalibrate my Oasys screen as it just wasn't responding as it should, the targets seemed to be way out and it just woudln't respond. Since calibration the target points are now working 100%. ( when I touch the larger buttons, I can see the button graphic change to show that Oasys knows the button has been pushed ) but I have found that with just a quick 'dab' the Oasys doesn't always do what the button is supposed to make it do.

( a good example of this is when saving a Combi and pressing the OK button ) - however if I touch the screen and hold my finger there for a while it works every time. Now I always touch and hold, it's better than touching 2 or 3 times to make thngs happen.

It's almost like there is a minimum contact time required with each touch of a screen button before oasys responds. It may be written into the code to reduce switch sensitvity and prevent 'bounce' ?

Korg Forums

OASYS touchscreen a bit sluggish since the 1.3.0 upgrade

Do you find the OASYS touchscreen a bit sluggish since the 1.3.0 upgrade?

OASYS touchscreen a bit sluggish since the 1.3.0 upgrade