Sustain problem after 2 min operation

madslund · Post by **madslund** » Wed Oct 03, 2007 3:31 pm

Hi guys

I have searced but can´t find any post with "my" problem.

I have a pa1xelite with a small problem. After I turn on the board everything is fine. But after aprox 2-3 min operation the upper notes get a close to endless sustain. Pressing shift+stop to reset cures the problem and after that everything is fine.

I upgraded sw from 2.5 to 3 + new music ressources. But no change.

It´s not a major problem but a little enoying to a great instrument.

any ideas ?

BR Mads

Post by **Sharp** » Wed Oct 03, 2007 3:58 pm

Do you have a non-KORG damper pedal connected.

Regards.
Sharp.

madslund · Post by **madslund** » Sat Oct 06, 2007 10:54 am

Hi

I have an Rolamd Pedal used for volume control on the upper parts. I'm on holiday right now, but will try to disconnect it when I get home.

When we are on pedals.... is ther avaliable specification on the input connector signals. Not that I don't like to buy Korg pedals but I have good avaliability of other brand of pedals and it will be a small case to modify them if I know the wireing and signal impedances.

BR
Mads

dschultze · Post by **dschultze** » Sun Oct 07, 2007 10:15 pm

Hello Mads,

I use both Technics and Yamaha pedals on my PA1X. I have to reverse them in the Global Controllers menu to make them work the right way round.

It sounds as if yours are not correct as the notes will sustain completely when your foot is off the pedal and might stop the sustain if you press the pedal.

Hope this helps.

madslund · Post by **madslund** » Tue Oct 09, 2007 1:26 pm

Hi again

Thanks for the advice. After unplugging the damper pedal everything is fine. I´ll start a vew topic on the diagrams.

Br Mads