MIDI synchronization between ESX (master)and EMX (slave)

Zmatekk7 · Post by **Zmatekk7** » Mon Sep 17, 2007 5:03 pm

Hi all,

please could you help me someone?

I have ESX-1 with EMX1. I need to know how can I change MIDI clock when I want to use ESX1 as Master and EMX as slave BUT!!! withnout change the Pattern Number...

I start ESX1 and EMX is also start, it is ok, BUT if I want change pattern in ESX1 - now automatic in EMX will change the pattern according ESX. I don´t want this!

Please do you know someone how can I switch off this setting?

I want use only tempo message from ESX to EMX, but no the same Pattern sequence

((

my setting is:
ESX - MIDI OUT cabel to
EMX - MIDI IN cabel

ESX - Clock = Int.
EMX - Clock = Ext. or Auto it´s not matter....

lsg · Post by **lsg** » Thu Sep 27, 2007 2:32 pm

check the page 80 in EMX manuel or 90 in ESX! "Midi Utility"

Zmatekk7 · Post by **Zmatekk7** » Sun Sep 30, 2007 2:44 pm

I try it! but there is only how can I set up synchronization with playing patterns...

lsg · Post by **lsg** » Wed Oct 03, 2007 3:39 pm

You have read it?

right? but you must try it!!! and play with PCEN (Filter) settings but if you put all of then to XXXX you'll get what you asked for.