View previous topic :: View next topic |
Author |
Message |
PIPMUSIC
Joined: 01 Apr 2022 Posts: 3
|
Posted: Fri Apr 01, 2022 11:08 pm Post subject: KRONOS ERROR PLEASE HELP!! |
|
|
Hello there, I have this Kronos for a year, bought it cheap with system error so been trying to fix it and I can't find the source of the error it reads like this:
System Error Id:000 Line: 0419
../MCU/Component/OmapL137Mcasp.cpp
so, I bought another main board and put it in, and still same error ...
so is not mainboard, any idea? Thank you so much![/b] _________________ PEDRO INIGUEZ PEREZ |
|
Back to top |
|
|
voip Platinum Member
Joined: 27 Nov 2014 Posts: 3792
|
Posted: Sat Apr 02, 2022 8:43 am Post subject: |
|
|
The OMAP quite likely refers to the KLM3002 ARM-powered board that does most of the heavy lifting on the Kronos. The issue might be caused by corruption of the SSD, or a fault on the board.
. |
|
Back to top |
|
|
robbie50 Senior Member
Joined: 06 Sep 2008 Posts: 345 Location: Holland
|
|
Back to top |
|
|
PIPMUSIC
Joined: 01 Apr 2022 Posts: 3
|
Posted: Sat Apr 02, 2022 5:51 pm Post subject: |
|
|
voip wrote: | The OMAP quite likely refers to the KLM3002 ARM-powered board that does most of the heavy lifting on the Kronos. The issue might be caused by corruption of the SSD, or a fault on the board.
. |
thanks for your reply, actually, yesterday I disconnected the SSD turn it on and show same error, today will disconnect every thing, clean all boards and cables and see what happen...Thanks again... _________________ PEDRO INIGUEZ PEREZ |
|
Back to top |
|
|
PIPMUSIC
Joined: 01 Apr 2022 Posts: 3
|
Posted: Sat Apr 02, 2022 5:52 pm Post subject: |
|
|
robbie50 wrote: | http://www.korgforums.com/forum/phpBB2/viewtopic.php?t=77891
Maybe here???
Robbie
|
Thank you for replay, nop nothing about it there, but thank you again... _________________ PEDRO INIGUEZ PEREZ |
|
Back to top |
|
|
KK Platinum Member
Joined: 13 Oct 2016 Posts: 1430
|
Posted: Sun Apr 03, 2022 9:03 pm Post subject: |
|
|
PIPMUSIC wrote: | voip wrote: | The OMAP quite likely refers to the KLM3002 ARM-powered board that does most of the heavy lifting on the Kronos. The issue might be caused by corruption of the SSD, or a fault on the board.
|
thanks for your reply, actually, yesterday I disconnected the SSD turn it on and show same error, today will disconnect every thing, clean all boards and cables and see what happen...Thanks again... |
Hi there, if it ends up being a failure with the OMAP board, note that in the case of a Kronos2, the KLM-3002 PCB is replaced by a KLM-3360 PCB. It might just be that it's lead-free compliant, but it might also be slightly different. I would for sure order the correct one to minimize risks of additional problems. |
|
Back to top |
|
|
|