View previous topic :: View next topic |
Author |
Message |
palindrome
Joined: 10 Sep 2015 Posts: 3 Location: Western Australia
|
Posted: Sat Sep 12, 2015 12:02 am Post subject: MS20ic Start up settings |
|
|
Hi,
Does anyone know how you can initially start the controller and VST up so the software reads the controller parameter settings?
At the moment the VST starts in a pre-programmed patch state and not how the controller is set up?? _________________ https://soundcloud.com/palindrome_au |
|
Back to top |
|
|
westikle
Joined: 02 Oct 2015 Posts: 7
|
Posted: Fri Oct 02, 2015 8:33 am Post subject: |
|
|
I second this motion. Would love to know this. |
|
Back to top |
|
|
westikle
Joined: 02 Oct 2015 Posts: 7
|
Posted: Wed Oct 07, 2015 10:44 am Post subject: |
|
|
Ok this is what I've noticed. If you have the controller turned off (via volume knob) it still works as a controller. When you turn the knob on, the vst instantly sets all parameters to match the controller. You can then turn it off again. |
|
Back to top |
|
|
|