Hello,
how do I switch Performances via Midi (brainspawn FORTE)? No Controllervalues found in Implementation-Card.
Hallo,
wie kann ich extern (mittels brainspawn FORTE) die Performances umschalten?
Best Regards/Grüße
Felixx
PA80: Performance-Selection via midi
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
I don't know about the pa80 but I own a pa50 which notes you can change performances with CC commands. (page 173 in my manual)
I believe you may need two CC, CC00 and CC32 but maybe a PC as well.
As I've not had a need to do this I'm not sure but looks like CC00 will always be 01 and then CC32 will be 00-19 that only gets you the 20 banks so you may need a PC on the end maybe try 0-7.
If you are stuck,, try email to Korg I'm sure they will reply.
hope it helps,, Phil.
I believe you may need two CC, CC00 and CC32 but maybe a PC as well.
As I've not had a need to do this I'm not sure but looks like CC00 will always be 01 and then CC32 will be 00-19 that only gets you the 20 banks so you may need a PC on the end maybe try 0-7.
If you are stuck,, try email to Korg I'm sure they will reply.
hope it helps,, Phil.
Pa50sd, JV1000, tg100