Sequencer mode MIDI tracks trouble. Help please!!

abhi30196 · Post by **abhi30196** » Mon Aug 06, 2012 2:04 pm

I have a Korg Kronos. I recorded a song upto half it's length using 10 tracks in the sequencer mode. I then saved it on a USB stick. When i switched off the system and restarted and reloaded the tracks in sequencer mode, my song played properly but when I tried to play (separately I.e. when my already recorded track finished playing) midi tracks 2,3,4 to record further, the tones wouldn't sound. All the other midi tracks sound except these three. Some help please?!

Post by **Sharp** » Mon Aug 06, 2012 2:11 pm

When you saved your song, did you save it as a SNG file or a Midi File ?
If it was a midi file, you should avoid that format completely as it does not store all the settings of your KRONOS.

To fix your problem try this....

Touch the “Track Parameter” page, and then touch the “Midi” page.

Make sure that the “Status” for all 16 tracks is set to BTH and not Off.

Regards
Sharp.

abhi30196 · Post by **abhi30196** » Mon Aug 06, 2012 2:15 pm

I saved it as a SNG file. And all the tracks are set to BTH. I even tried restarting and reloading the song three four times.
Please help

Post by **Sharp** » Mon Aug 06, 2012 2:21 pm

Are the sounds you have selected in SEQ mode working in PROG mode ?

Regards
Sharp.

abhi30196 · Post by **abhi30196** » Mon Aug 06, 2012 2:53 pm

Yes they are working

Post by **Sharp** » Mon Aug 06, 2012 2:57 pm

Very odd.
I would have to see your SNG file to figure this one out.

Regards
Sharp

Shakil · Post by **Shakil** » Tue Aug 07, 2012 12:08 pm

did you check the mute status and track levels? Were the same tracks sounding before?

did you start the song from a Combi? A lot of combis have KARMA setup where the tracks do not sound, they are only used to pass through karma midi to other tracks.