KORG T3 ex, Can not load PCM Data after repair
Posted: Wed Nov 09, 2022 11:20 am
On my T3 Ex i replaced the Display with a new LED Display. Within this procedure i also replaced all buttons and did the modifications to the power Unit (removed capacitor and transisitor to cancel the power supply for the display).
After rebuilding everything the new display and al buttons worked fine.
But then i noticed, the Oscillators above 99 were missing. I tried to load everything form the original t3 Disk i found in my Box an there i noticed that under Disk the entry for "Load all PCM Data" is missing.....
Can you tell me what could be broken, which cable/Board can be responsible for that?
Any suggestions may help!
Thank you
Marc
After rebuilding everything the new display and al buttons worked fine.
But then i noticed, the Oscillators above 99 were missing. I tried to load everything form the original t3 Disk i found in my Box an there i noticed that under Disk the entry for "Load all PCM Data" is missing.....
Can you tell me what could be broken, which cable/Board can be responsible for that?
Any suggestions may help!
Thank you
Marc