Page 1 of 1

how do you set delay parameters

Posted: Wed Jul 01, 2020 7:35 pm
by amit
how do you set delay to custom times, all I see is predefined presets?
for example i want to set lcr to l:250 R:275.
threre must be someplace where these presets are made or saved

Posted: Thu Jul 02, 2020 7:12 pm
by fjs714
amit, This is the BEST korg forum in the world. But if you need something really specific----Check out Ultimate Korg Wavestate on Facebook.

Frank

Re: how do you set delay parameters

Posted: Fri Jul 03, 2020 1:22 am
by danatkorg
amit wrote:how do you set delay to custom times, all I see is predefined presets?
for example i want to set lcr to l:250 R:275.
threre must be someplace where these presets are made or saved
The wavestate effects support wet/dry, three macro edit controls (EDIT 1/2/3), and sometimes additional input or output level controls. Low-level editing for effects is not supported.

The FX EDIT 1/2/3 controls are macros which may control multiple internal parameters, and which may be set up differently for each Preset. Names for the knobs, specific to the selected effect, are shown on the display. The delay effects allow you to control Time, Feedback, and Timbre. For tempo delays, Time will select different note values; the TEMPO button then controls the overall length. For non-tempo delays, Time generally directly scales the delay times.

Posted: Fri Jul 03, 2020 3:42 am
by amit
Thx Dan,
I did figure that the time knob was dialing in some multiple of preset name indication. Can live with that
Only wish if there was a way to adjust reverb send per layer as there are no hardware outputs for layers for individual processing.