Page 1 of 1
Minilogue midi settings with electribe2
Posted: Wed Jun 12, 2019 5:41 pm
by roblabs
So this is annoying. The midi settings between both the minilogue and e2 do not allow one to keep midi note messages on while turning off program changes.
I have the e2 set as the master, sending midi note messages on ch1 to the minilogue , but I do not want the minilogue to change programs when I chance a pattern on th e2. Has anyone found a workaround for this?
Re: Minilogue midi settings with electribe2
Posted: Mon Jun 17, 2019 3:15 am
by TheDoctor
roblabs wrote:So this is annoying. The midi settings between both the minilogue and e2 do not allow one to keep midi note messages on while turning off program changes.
I have the e2 set as the master, sending midi note messages on ch1 to the minilogue , but I do not want the minilogue to change programs when I chance a pattern on th e2. Has anyone found a workaround for this?
Are you sure in the Minilogue you can't filter program change?
Posted: Mon Jun 17, 2019 4:18 am
by roblabs
In the minilogue and monologue (I have both) all you can do is turn midi send and receive on or off. There are no filter settings for this.
Posted: Thu Jun 27, 2019 5:20 am
by slug
Interesting - the XD version allows program change filtering.
Posted: Thu Jun 27, 2019 7:29 am
by TheDoctor
roblabs wrote:In the minilogue and monologue (I have both) all you can do is turn midi send and receive on or off. There are no filter settings for this.
You have 3 option:
Enable RX midi for received midi
En RX Transport for start,pause...
Enable TX midi for transmitted midi
You can also set the Minologue as master and filter program change in the Electribe.
Also looking at the Monologue midi implementation say Program Change 0-99, did you try to set patch 100? What happen.
Posted: Fri Jun 28, 2019 10:44 pm
by TheDoctor
TheDoctor wrote:roblabs wrote:In the minilogue and monologue (I have both) all you can do is turn midi send and receive on or off. There are no filter settings for this.
You have 3 option:
Enable RX midi for received midi
En RX Transport for start,pause...
Enable TX midi for transmitted midi
You can also set the Minologue as master and filter program change in the Electribe.
Also looking at the Monologue midi implementation say Program Change 0-99, did you try to set patch 100? What happens
Edit: the Minologue just got an update for midi filter, I didn't have time to check but maybe they address what you're looking for
Edit: Minilogue and Monologue got a new update where they open the midi setting. You can set program change, CC, pitch bend both send and receive, transport only received.
Posted: Sat Jun 29, 2019 1:31 am
by roblabs
Amazing! You know, when I created this post topic, I also emailed korg customer support and asked them if they can add in midi filter settings in a firmware update. Might it be possible that they actually listened to me!?
Posted: Sat Jun 29, 2019 9:06 am
by TheDoctor
roblabs wrote:Amazing! You know, when I created this post topic, I also emailed korg customer support and asked them if they can add in midi filter settings in a firmware update. Might it be possible that they actually listened to me!?
Who knows man! It could be, that's why I suggest to email company anyway. Multiple times too if they don't reply.
We should do that for the Electribe too
