Korg Forums

I tried so much to understand how it works, cant figure out?
when ever i merge some sound or some drum kits in the same set from different sets to make my own selection set, when i go back to test it to check the sound or those drumkits it appear no sound look like not saved the same not included sound weird, which suposed to load the sample with the sound or drum kit right? but as soon as load one and is correct, then will affect the rest drum kids and loos the sound or no sound at all? so what is i am doing wrong, for information i have korg pa 800 256 MB upgraded when i ever i check the sound mode and smaple info is 0 sample available or it is full or nothing? what is wrong here.can some one explain of course every step even i save all too and go back nothing!

dilan wrote: .... how it works, cant figure out?!

Sampling info (in SampleEditMode) only show info on the sample in edit, but has nothing to do with SampleSetup of DrumKits in SoundOperatingMode, where you can select a different percussive samples for each key and layer.
Samples you select for a current layer from RAM (user-loaded or created samples) or ROM (internal factory preset samples).
If using RAM samples for your Drumkit you must loaded them from the internal SSD-S memory (hidden PCM folder --> “PCM Autoload” and “Load PCM button” on page 258 of the User’s Manual - Media mode).
In case RAM-samples are not loaded, no sound will be heard, even if the DrumKit can be selected and its name appears in the display.
*
In SoundOperatingMode you select different percussive sample for each key and layer for a DrumKit. Before you leave this mode it is necessary to use command "Write Sound" of page menue. So you can save your Drumkit-Sound parameters to a User-Drumkit-Sound location in memory (DrumKits cannot be written over standard Sounds). To save over a Factory Drumkit-Sound location, uncheck the Factory Sound Protect parameter in Media mode.